The USB2-GPIB Converter enables you to remotely control an oscilloscope from a PC using standard GPIB commands.
The USB2-GPIB Converter enables you to remotely control an oscilloscope from a PC using standard GPIB commands.
The GPIB connector conforms to IEEE488.2 standard. Its delimiter setting is LF+EOI. The USB connector conforms to USB 2.0 and minimum firmware version required for this device is 7.3.0.x.
| Power Feed | Bus-powered |
| USB Standard | Conforms to USB Specification Revision 2.0 |
| USB Connector | Type A |
| GPIB Connector | Amphenol 24-pin (male) |
| Power Consumption | 350mA at the maximum (during operation) |
| Operating Temperature | 5 to 40°C |
| Storage Temperature | -40 to 71°C |
| Operating Humidity | ≤80% RH (Non-Condensing) |
| Operating Altitude | 10,000' (3048 m) max at ≤25°C |
| Cable Length | 29.5" (750 mm) |
| External Dimensions | 2.4 x 0.86 x 4.4" (61 × 22 × 113 mm) |
| Weight | 140 g |
| Power Feed | Bus-powered |
| USB Standard | Conforms to USB Specification Revision 2.0 |
| USB Connector | Type A |
| GPIB Connector | Amphenol 24-pin (male) |
| Power Consumption | 350mA at the maximum (during operation) |
| Operating Temperature | 5 to 40°C |
| Storage Temperature | -40 to 71°C |
| Operating Humidity | ≤80% RH (Non-Condensing) |
| Operating Altitude | 10,000' (3048 m) max at ≤25°C |
| Cable Length | 29.5" (750 mm) |
| External Dimensions | 2.4 x 0.86 x 4.4" (61 × 22 × 113 mm) |
| Weight | 140 g |
