Cable Tracker Tone and Probe Kit for identifying connected hub or switch ports by activating link lights. Includes four audible tones, RJ-45 connections, detachable DMM alligator clips, and tests for short or open circuits.
Cable Tracker Tone and Probe Kit for identifying connected hub or switch ports by activating link lights. Includes four audible tones, RJ-45 connections, detachable DMM alligator clips, and tests for short or open circuits.
Toning an active LAN circuit can disrupt network traffic and is difficult to track due to cable twist and tone bleed. The CableTracker Network Tone and Probe Kit features a Port ID function that blinks the link light verifying cable connectivity. This feature also provides a simple and effective method to identify switch or hub port assignments on active networks. Three different blink rates are provided to ensure compatibility with equipment from a wide range of manufacturers.
Traditional toning with two different tone frequencies and patterns is provided for non-active circuit tracing.The Cable Tracker model CTK1015 incorporates several time and money saving features not found on other kits. The RJ-45 male connection and the alligator clips are detachable and commonly available, meaning cord failure won't obsolete your tester. Auto power down extends battery life and a built-in low battery indicator warns when battery replacement is required, saving unexpected down time searching for batteries.
The CableTracker Network Probe Model CTK1015 incorporates volume control, a non-conductive plastic tip, and complete compatibility with existing toners. From a wall outlet, blink a Hub or Switch link light to identify a connected port, three selectable blink rates provide the widest compatibility with LAN equipment, and find cables hidden in walls and ceilings. Transmits two audible tones and with two selectable patterns, detect shorts using built-in continuity check, detachable alligator leads as well as an RJ-45 jack and carry case included.
Caractéristiques
Applications
Signal Generator (CT10) | Dimensions: 3.0 in. x 2.4 in. x 1.4 in. 76 mm x 66 mm x 36 mm |
Probe (CT15) | Dimensions: 8.0 in. x 1.4 in. x 1.5 in. 203 mm x 36 mm x 38 mm |
Environment | Operating Temperature: 0 to 50°C Storage Temperature: -10 to 55°C |
CT10 Signal Frequencies | Lo Tone: 1000 Hz pulsed Hi Tone: 8 kHz pulsed |
Power Supply | One 9 volt battery each for CT10 and CT15 (not sUpplied) |
CT15 Reception Frequencies | Broadband 100 to 20000 Hz |
Signal Generator (CT10) | Dimensions: 3.0 in. x 2.4 in. x 1.4 in. 76 mm x 66 mm x 36 mm |
Probe (CT15) | Dimensions: 8.0 in. x 1.4 in. x 1.5 in. 203 mm x 36 mm x 38 mm |
Environment | Operating Temperature: 0 to 50°C Storage Temperature: -10 to 55°C |
CT10 Signal Frequencies | Lo Tone: 1000 Hz pulsed Hi Tone: 8 kHz pulsed |
Power Supply | One 9 volt battery each for CT10 and CT15 (not sUpplied) |
CT15 Reception Frequencies | Broadband 100 to 20000 Hz |