IMADA I-80 offre

The Series i torque calibrator measures the peak torque non-impact electric/air drivers applied to a screw. Under tightened bolts and screws do not generate sufficient clamp force and can lead to loosening and assembly failure. Over tightening, past the yield point, permanently deforms the screw joint and can also lead to failure which is why proper tightening torque is so important.

Unique Smart Adapters simulate the screw joint and do not need to be backed-off after each test. This features increased testing efficiency and ease of use by reducing the time between each test. Results can be downloaded through the USB port for analysis with data acquisition software. The i Series Torque Calibrators are compatible with Imada's SW-1SV-USB software.

Caractéristiques

• Measuring range of 0.20 to 69.70 lbf-in
• Selectable units lbf-in, Kgf-cm, N-cm and N-m
• Programmable High/Low setpoints with audible beep for uniform torque tightening or GO/NO GO testing
• Comes with smart adapters
• Peak, Real Time and Peak Down measuring modes (selectable)
• Measure both clockwise and counterclockwise
• USB virtual COM port sends peak (1 data) or continuous data (12 or 180 data/second)
• Statistics the Number of Data, Max, Min, and Avg
• Heavy-duty metal construction
• Runs on internal NiCad batteries or AC adapter
• 3/8" drive for socket wrenches