Providing an efficient and safe method to apply a locate signal to a cable, this clamp is used with the UAT-600 transmitter, enabling it to induce a signal through the insulation into wires or pipes.
Providing an efficient and safe method to apply a locate signal to a cable, this clamp is used with the UAT-600 transmitter, enabling it to induce a signal through the insulation into wires or pipes.
Built to last, this signal clamp makes it possible to gain access to a cable for making an electrical contact. Offering complete safety, this accessory provides an efficient and safe method of applying a locate signal to a cable.
Features
| Measurement Category | CAT IV 600 V |
| Operating Voltage/Current | 0 to 600 V, 100 A max |
| Operating Frequency/Tracing Modes | 33 kHz and 8 kHz |
| Signal Voltage Output (Nominal) | 23 V rms at 8 kHz 30 V rms at 33 kHz |
| Operating Temperature and Humidity | -4 to 122°F (-20 to 50°C), ≤90% RH |
| Storage Temperature and Humidity | -40 to 140°F (-40 to 60°C), ≤90% RH |
| Operating Altitude | < 6561 ft (< 2000 m) |
| Pollution Degree | 2 |
| Water and Dust Resistance | IP54 |
| Drop Test | 3.28' (1 m) |
| Size (H x W x L) | Approx. 11.6 x 7.1 x 1.4" (295 x 180 x 37 mm) |
| Weight | Approx. 1.9 lb (0.85 kg) |
| Measurement Category | CAT IV 600 V |
| Operating Voltage/Current | 0 to 600 V, 100 A max |
| Operating Frequency/Tracing Modes | 33 kHz and 8 kHz |
| Signal Voltage Output (Nominal) | 23 V rms at 8 kHz 30 V rms at 33 kHz |
| Operating Temperature and Humidity | -4 to 122°F (-20 to 50°C), ≤90% RH |
| Storage Temperature and Humidity | -40 to 140°F (-40 to 60°C), ≤90% RH |
| Operating Altitude | < 6561 ft (< 2000 m) |
| Pollution Degree | 2 |
| Water and Dust Resistance | IP54 |
| Drop Test | 3.28' (1 m) |
| Size (H x W x L) | Approx. 11.6 x 7.1 x 1.4" (295 x 180 x 37 mm) |
| Weight | Approx. 1.9 lb (0.85 kg) |
