Mark-10 AFCOMP-H Offers

Features

• FollowMe - Crosshead movement responds to manually pushing or pulling on the load cell. Increasing force produces greater speeds. Ideal for setups and quick positioning
• Travel Measurement - Travel is indicated on the control unit display, with output via USB. An internal scale utilizing technology produces significantly higher accuracy than with conventional rotary encoder-based designs
• PC Control - The EM303 and ESM303H may be fully controlled by a PC through a program written in any language supporting ASCII communications
• Travel Limits - The stand stops at or cycles between programmable right and left travel distances
• Overload Protection - Protects a load cell against overload. Program the desired percentage of full scale of the load cell. Adjustable analog voltage setting allows the stand to interface with virtually any instrument with analog output
• Auto Return - The crosshead moves to a limit switch, force set point, travel position, or break, then stops and reverses direction at full speed to the opposite limit
• Cycling/Dwell Time - Same as auto return, but with the ability to program up to 100,000 cycles. Programmable dwell time for right and left limits (set independently) can be set up for up to 10,000 seconds
• Independent Right/left Speeds - Individually configure speeds for the right and left directions
• Low Speed Extension - Extends the standard speed range down to 0.02 in/min (0.5 mm/min)
• High Speed Extension - Extends the standard speed range up to 45 in/min (1100 mm/min)
• Break Detection - Crosshead stops at a sudden drop in force. Programmable percentage of peak force
• Load Holding - Dynamically adjusts the crosshead position to maintain a programmed load for an indefinite or specified period of time
• Preload - Stops the crosshead and/or zeroes the travel display at an initial preload - useful in tensile, compression, spring, elongation, and other applications. Preload is programmable as a percentage of force gauge/load cell full scale. Three modes: (1) stop, (2) stop and zero, and (3) zero without stopping
• Profiles - Save and recall sets of test parameters, such as speeds, travel limits, preloads, etc. Up to 50 profiles may be stored

Applications

• Laboratory and production testing
• Break testing
• Cycling
• Limit testing
• Load holding
• Elongation testing
• Tensile testing
• Compression testing